To set up trunks and select port members, use the Link Aggregation page. Advertises the port capabilities of a given interface during autonegotiation. Connect all your devices like shown on following network diagram.
|Date Added:||15 February 2011|
|File Size:||27.7 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Switch Administrator: Dell PowerConnect 27XX Systems User's Guide
For each trunk number switxh in the Trunk column, you can change the following parameters listed by column administrahor on the screen:. The device must be changed to Managed Mode before it can be configured.
For information about recovering a lost password, see " Switch Default Button ". Configure Port Mirroring function on the switch. Allows you to view classes of entries in the bridge-forwarding database. From the Port Mirroring page, you can openmanae a port mirror session by setting a source and destination port pair.
The Port Settings page is set up in a table format. Advertises the trunk capabilities of a given interface during autonegotiation. If one link in the trunk fails, one of the standby ports is automatically activated to replace it.
For configuration changes to persist beyond the current session, you must save the running-config file from this page, or use the CLI command copy running-config startup-config. This allows you to try a new version of the software without overwriting the previous version.
Dell Switch PowerConnect Default Router Login and Password
Broadcast control does not affect IP multicast traffic. From the Bridge Settings page, under Attributesyou can also enable and configure the following Spanning Tree parameters:. The switch provides more efficient large sequential data transfers by supporting jumbo frames up to bytes.
Port 9 to Depending on the option selected, the area at the bottom of the Ethernet switch view displays other Ethernet switch information or dialog boxes for configuring parameters.
Use the no form command to disable it. In the Del Settings page, you can specify Spanning Tree parameters for each port. From the Configuration page you can save and restore switch configuration settings.
On the Traps page, you can specify management stations that receive authentication oppenmanage messages and other trap messages from the switch. The default user names are admin and guestand the corresponding passwords are admin and guest. The source and destination port have to be either both in the port range of 1 to 12 or both in the port range of 13 to To disable flow control, use the no form command.
Legacy documentation Legacy documentation Passive call recording setup What is port mirroring? On the Traffic Classes page, you can configure the mapping of frame priority tags to each port's four CoS adminiistrator queues.
To save any changes you make in this page, click Apply Changes. Use the no form command openmanag remove a port from a trunk. Analysis port works in read-only mode. Powered by Atlassian Confluence 6.
The Switch page contains all system operations and general information. The default IP address is Sets the number of seconds the switch openmanagr for a reply before resending a request.
Dell PowerConnect 2700 Series
On the Trunk Configuration page, you can enable and disable the aggregate port links administratr have been created on the switch. Use the no form command to restore the default weights. You can use the IGMP Member Port Table page to assign ports that are attached to hosts that are supposed to receive a specific multicast service.